![]() ![]() In this blog, we will identify some of these lousy tensioner pulley symptoms as well as the effects a A wobbly crankshaft pulley can be a real headache, as it can cause all sorts of problems with your car. The level of looseness will create different sounds. It sounds like it is coming from around the crankshaft pulley area. Other Things to Try For Kawasaki Rear Brake Issues: Other Kawasaki Models With Reported Rear Brake and Caliper Problems 5. if the engine is running well, i would just torque it to 140 ft lbs and keep an eye on it in the future. That can result in needing a new crankshaft which is many $$$. Choose the socket which fits your crankshaft pulley bolts. Replaced all the idler pulley and tensioner pulley… replaced the alternator. This is also a good time to check the timing belt. What’s worse is that the engine can suffer This is just to stop the blade from spinning around as you tighten it. ![]() A loose idler pulley can cause a belt to become off-balance, resulting in the belt falling off. The aforementioned Craftsman 19mm deep socket failed after years of use with an 18-inch, 1/2-inch drive breaker bar (1/2-inch to 3/8-inch adapter attached). I usually leave the crank pulley on and use that to grip with pliers, most crank pulleys neck down to a smaller diameter than the harmonic balancer, since the pliers only go to about 8". The block will ensure it stays in one place and makes the job much, much easier. The sound may vary with the speed of the engine. Remember the two aspects of the combustion process that relies on input from the crank sensor – the fuel injection, and ignition. If it shows signs of wear, including cracking or worn-out teeth, then it should be replaced. The most important factor is lubrication. But for about a day before I clued in I heard a loud tapping sound which increased with RPMs. ![]() One week later engine light went on, brought immediately to dealer. Thanks guys your advice has been very helpfull and accurate. Engine Vibration One of the most common symptoms of a bad crankshaft pulley is excessive engine vibration. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |